| - |
The downloaded program is available for owners of the TS-480HX/480SAT. |
| - |
This program runs on Windows® 2000 (SP4 or later), Windows® XP (SP2 or later), or Windows Vista™(*). |
| - |
To update your TS-480HX/480SAT firmware, an RS-232C straight cable is required. |
| - |
About 1MB of free hard disk space is needed to install this program. |
| - |
At least 5MB of memory is required to run this program. |
| - |
Users may not engage in the following acts:
To revise, change, edit, merge, de-compile or reverse engineer the Software. |
| - |
The quality and performance of the product shall not warrant the applicability to the purpose of any user. KENWOOD shall not assume any liability for defects, or warrant anything other than expressly provided in the document. The selection and introduction of the products as well as the results therefrom shall be upon the liability of the users. |
| - |
This firmware updating program cannot read and write user data such as menu items, memory channel frequencies. |
| - |
If you do not want to lose user data, save the data using the Radio Control Program ARCP-480 before updating the firmware and write the data back after updating the firmware. |
 |
|
| |
(*) Windows, Windows Vista are either registered trademarks or trademarks of Microsoft Corporation. |
